IP67 Shatterproof Light Fitting
TR-2 all sizes and wattages single and twin.TR-3 all sizes and wattages single and twin.
TR-4 all sizes and wattages single and twin.
Fluorescent Luminaires for Industrial Areas Type RGP-FFL.F.
Plastic non rusting fluorescent luminaires type RGP-FFL.F are designed to illuminate public and maintenance areas such as lift shafts and elevator bays where dust, humidity, wet, dry or corrosive/aggressive environments and temperature conditions of -20ºC to + 60ºC are present. The Shatterproof Lamps are IK7 EU Approved in any colour rendering and wattage. RGP-FFL.F. 136 Standard FinishRGP-FFL.F. 136N Uncompensated Finish
RGP-FFL.F. 136S Finish with Series Compensation
RGP-FFL.F. 136R Finish with Paintong Reflector
RGP-FFL.F. 136EP Finish with Electronic Ballast
RGP-FFL.F. 136O Finish with Protect Polycarbonate Tube
Manholes Distance for Luminaires Fixation
Protection: IP65
Class: I
Supply Voltage: 230V + 6%, -10% / 50Hz
Applicability to normally inflammable background direct mounting.
Mounting Instructions
1) Screw off connecting flap locks on luminaire body: 3pcs (for luminaire 1 x 36, 2 x 36), 4pcs ( for luminaire 1 x 58, 2 x 58), 2pcs (for luminaire 1 x 18, 2 x 18).2) Screw on fixation screws with gasket on designated place (LF).
3) String a needle lower part of body on fixing screws through mounting holes dia 11 and attach pad with notch according set way (detail A) by means of:
(screw head diameter: dia 10mm)
4) Thread a service cable through cable gland inside body and fix it to terminal block. Diameter of cable 6 ÷ 10mm.
5) Put a lower part of body on upper part and ensure with flap locks.
6) Unscrew cap nut from lamp holders and put on lamps. Unscrew igniter plugs and install igniters into socket. (IF POSSIBLE INSTALL THE FLUORESCENT LAMPS AND INGNITERS YOU HAVE, FROM THE SAME PRODUCER).
RGP Endcap Protection Tube Mounting:
Picture. 1Picture. 2
Connection by copper cable 3 x 2.5mm² and quick release electrical couplings.
Thread cable through gland and connect it to the terminal block.
ATTENTION: Connector cable must no be connected on the side with longer distance between cable gland and terminal block because of possibility damage of cable isolation by ballast.
Products
Links
